Digital Spectrum MemoryFrame MF-8000 Especificaciones descargar pdf (Pagina 94)

100

101

DATA modes. If CW_U gives CW-R on your transceiver, check CW Reverse in the

TRX-Manager's Preferences/Transceiver tab.

JUMA TRX2

TRX-Manager supports the JUMA TRX2 transceiver loaded with the firmware modified by

Adrian 5B4AIY : Version 1.07wb10 or later. You have to configure your Juma with RS232:

JUMA TRX2 and (recommended) Baud Rate:115200. TRX-Manager uses the extended

auto-information mode of this firmware and simultaneous control of the PA100D is still possible

using an Y cable.

TRX-Pan + TRX-Manager works fine with a JUMA TRX2 using the I/Q output of the rig.

However, since TRX2 uses a phasing and I/Q are reversed between LSB and USB, you have to

set up TRX-Pan with: Flip I/Q (not checked), CW:Flip (checked), USB:Flip (checked). You

also have to set up an Offset = Pitch value in CW (in kHz).

With the distribution of TRX-Manager, a stand alone (freeware) application is included:

TRX-Juma. TRX-Juma provides control of the main functions of this transceiver and its

interface mimics the TRX2's front panel. You can not run TRX-Manager and launch

TRX-Juma.exe simultanously, however, the TRX-Juma's interface is also available from

TRX-Manager using the External/TRX-Juma submenu.

TRX-Juma's interface

Page 94

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 422 423

Comentarios a estos manuales

Sin comentarios

Digital Spectrum MemoryFrame MF-8000 Especificaciones Pagina 94

Comentarios a estos manuales

Relacionado con productos y manuales para Marcos de fotos digitales Digital Spectrum MemoryFrame MF-8000